Channel 14 enabled locks up readings
Submitted by seabear70 on Sun, 01/13/2008 - 11:16.
When I enable channel 14, on either chanalyzer two or three, all reading stop.
The tab goes blank with nothing but grid lines, and if I close the tab and open a new one, I lose channel 14.
What can I do to fix this?
Good catch! Chanalyzer wasn't checking if the Wi-Spy was a Wi-Spy v1 or a Wi-Spy 2.4x. Since Wi-Spy v1 can't configure it's frequency range it couldn't display the data for channel 14, which would cause the crash. This problem has been fixed in Chanalyzer 3.0 Beta 4. The channel 14 preference is now ignored for Wi-Spy v1.
Ryan
Chief Geek - MetaGeek, LLC